This is what you should do when your car's tires punctured while on the road.
- Turn on hazard light as soon as possible
- Drive slowly to the save place; avoid jacking up your vehicle in/on the yellow or white line (road boarder). If possible 1 meter or 5 feet outside road boarder line. A lot of cases where the victim was hit while changing their tire at the roadside.
- Do not park your vehicle after and before the corner or sharp bend. Find place where the other motorist can spot you from far as they can.
- Drop the emergency triangle reflector 30-40meter away ahead from your vehicle. Remember to put it just next (inside) to the road border line, not at the middle of the road.
- Take out all the equipment to change the tire as well as spare tire.
- Before start lifting the vehicle, make sure the ground surface are flat and tough enough to support the heavy weight
- Loosen the lug nut by applying proper loosing/tightening sequence (refer picture below), but not too much, enough to make it loose. If you cannot loose the lug nut by hand, try using your weight by steping onto the spannar and bounce on it slowly while both your hand holding something to stabilize your body. And then start lifting the vehicle. Please make sure handbrake has been engaged.
- Lift the car until the tire hanging from the ground. Before removing the tire, place the spare tire under the car as a precaution in case the jack fails to function properly especially hydraulic-type jack.
- When the punctured tire removed from the wheel hub, replace it with the spare tire immediately.
- Screw back the lug nut by hand first until the tire cannot be shake anymore before lowering the vehicle. Then remove the jack and start applying force to the lug nut by using proper lug nut tightening/loosing sequence.
- Keep back all the equipment to its place. Remember to take back the emergency triangle reflector and turn off the hazard light before applying signal light for entering the road.
Thats all. Have a save journey..
0 comments:
Post a Comment